Simonton Window Installation Nationwide | TruePane Windows & Doors

Simonton Window Installation: The Wellington Owner’s Guide

Simonton window installation in Wellington typically runs $85 to $240 per window for a sash, balance, or hardware replacement, and $450 to $1,100 per opening when the entire frame and glass unit need to come out and go back in square. We stock the most common Simonton replacement parts on our trucks, so a single-window repair is usually finished the same day we arrive. Most Wellington homeowners don’t discover the problem until a window won’t stay up, won’t lock, or starts whistling during an August thunderstorm.

Call (561) 349-4826

We’re an independent installer, not affiliated with Simonton, but we’ve been matching their parts and setting their windows across Palm Beach County long enough to know which components fail first around here. More on that below.

Key Takeaways

• Simonton parts are model-specific. A balance from a Reflections 5500 won’t fit a DaylightMax 6500 without modification.
• Most repairs run $85 to $240 and are done in one visit.
• Full replacement installs in Wellington run $450 to $1,100 per opening depending on frame condition and impact rating.
• We stock balances, pivot bars, tilt latches, and weatherstripping for current Simonton lines on the truck.

Which Simonton Models This Applies To

Simonton has built windows under a lot of names over the years, and the part that fits one series often won’t fit another. In Wellington, we work on Reflections 5050 and 5500, DaylightMax 6000 and 6500, ProSolar, Impressions, and the older Madeira vinyl lines that Simonton retired. Each series uses its own balance system, and even within a series, the sash weight and glass package determine which balance strength you need.

Here’s what to check before you call. Open the sash and look for a sticker on the top edge of the frame or the side jamb. Simonton prints the series name, the window size, and a manufacturing date on a label that usually survives Florida humidity. If the label is gone, measure the visible glass width and height to the nearest eighth of an inch, and take a photo of the balance mechanism at the side of the sash. We’ll match it from those two things plus the year the house was built or windows were installed.

One compatibility gotcha we see weekly: homeowners buy aftermarket tilt latches online that claim to fit “all Simonton windows,” and the screw holes are off by a quarter inch. That’s not close enough. OEM Simonton latches cost a few dollars more and seat correctly the first time. For balances and pivot bars, we stock OEM and quality aftermarket equivalents from a Florida distributor we’ve dealt with for fifteen years. We’ll show you both options on paper with prices before we touch the window.

Signs Your Simonton Window Installation Is Failing

• Sash won’t stay up, or drops when you let go. The balance system has lost tension. In Wellington’s salt air and heat, coil and block-and-tackle balances lose spring force after eight to fourteen years. If you have to jam a stick under the sash to keep it open, the balance is done.
• Window whistles or leaks air at the meeting rail. The weatherstripping has compressed or torn, usually at the point where the top and bottom sash meet. You’ll notice it most during August thunderstorms when wind drives rain against the east-facing windows.
• Lock won’t engage, or you have to force it. The keeper and lock body have shifted out of alignment, often because the sash settled and the frame racked slightly. Forcing the lock is how keepers snap off.
• Sash won’t tilt in for cleaning, or it tilts but won’t re-seat. The tilt latches are worn or a pivot bar is bent. This is the most common part failure after balances on Simonton double-hungs in Wellington.
• Condensation between the glass panes. The insulated glass unit seal has failed. That’s a glass replacement, not a hardware issue, but it’s the one sign that means you need a same-day window out, reglazed, and back in. In Florida, a failed seal shows up first as a milky haze on the southern and western exposures.

Replacement Cost & What’s Included

Here’s what we charge in Wellington for the most common Simonton repairs:

• Balance replacement: $85 to $160 per sash, parts and labor included. Coil balances run the lower end; block-and-tackle balances run higher.
• Tilt latch replacement: $65 to $120 per window. OEM latches at the top of that range.
• Pivot bar replacement: $85 to $130 per sash.
• Weatherstripping replacement: $70 to $140 per window depending on the seal type.
• Full window frame replacement with Simonton or comparable unit: $450 to $1,100 per opening. The spread depends on whether the existing frame is square, the glass package you choose, and whether the unit needs to carry an impact rating.

Every quote is written before we start, and the number on the quote is the number on the bill. No surprise line items after the fact. Every repair and installation carries our Done Right Promise, and if the window was purchased through us, we register both manufacturer warranty layers in writing before the truck leaves the driveway. That’s the Keystone Standard, and it applies to every job we do in Wellington.

DIY or Call Us?

What you can safely check yourself: whether the window label is visible, whether the sash lifts straight or binds on one side, and whether the problem is the lock, the tilt latch, or the balance. None of that requires tools, and knowing it saves us time on the phone.

What you shouldn’t attempt: removing a sash to access a block-and-tackle balance without knowing how to release the tension. Vinyl double-hung balances are under constant load, and a coil balance that lets go can take a finger or a palm with it. We’ve also repaired windows where a homeowner tried to swap pivot bars with a drywall screw, which strips the balance shoe and turns a $110 repair into a $240 one. If the balance is still under tension or you’re not sure how to release it, call us. A trained technician does this job in about half an hour, and the workmanship is guaranteed.

Call (561) 349-4826 and we’ll talk through what you’re seeing. If it turns out to be something simple, we’ll tell you over the phone and save you the trip.

FAQs