Sliding Glass & Patio Doors

Sliding Glass & Patio Doors in Wellington, FL | TruePane Windows & Doors

Sliding glass and patio doors open your home to Florida light while standing up to the weather Wellington actually gets. These are large-span impact door systems with laminated glass panels riding on a reinforced track, engineered to the same wind-zone design pressures as our window lines. Homeowners across Wellington choose them for pool access, lanai transitions, and great-room walls that face the preserve or the water. TruePane Windows & Doors supplies and installs these systems across our PGT, CGI, CWS, ES Windows, ECO, and Mr-Glass lines, and we’ve been setting them level, plumb, and square in Wellington homes for years. Call (561) 349-4826 to talk about your opening.

Call (561) 349-4826

Product Overview - Sliding Glass & Patio Doors

A sliding glass door in South Florida is not a decorative afterthought. It is a structural component of the building envelope, and in Wellington it has to perform like one. The impact series sliding doors we install are built around laminated glass panels held in reinforced aluminum or vinyl frames. When wind-borne debris hits the glass during a storm, the PVB interlayer holds the shattered pane in place instead of letting it blow into your living room. That is the entire point of the product, and it is the reason Wellington homeowners replace older sliders that predate current Florida Building Code requirements.

Architecturally, these doors earn their place on rear elevations, pool decks, and any wall where you want an uninterrupted sightline. The track system supports openings up to 12 feet wide, so a single door assembly can carry a substantial span without a center post breaking the view. Frames come in aluminum or vinyl, each with its own strengths: aluminum for thinner sightlines and larger glass area, vinyl for thermal performance and resistance to coastal salt air. The rollers, interlocks, and track hardware are matched to the weight of impact glass, which is meaningfully heavier than standard annealed glass, and that matters for how the door operates day to day.

TruePane Windows & Doors supplies these systems to Wellington homeowners who want the door to glide easily and seal tightly. We install per AAMA 2400/2410 practice, with the perimeter sealed using AAMA 812 low-expansion foam, and we pull and verify to make sure the door is level, plumb, and square before the trim goes back on. A sliding door that binds or leaks in Wellington usually fails because of installation shortcuts, not the product itself.

Technical Specifications

• Frame materials: Aluminum, Vinyl
• Maximum width: Up to 12 feet
• Track configurations: 2-Track, 3-Track
• Glass options: Laminated Impact Glass with PVB Interlayer, Low-E Insulated Glass, Tinted Glass, Clear Glass
• Finish options: White, Almond, Bronze, Black, Tan
• Screen options: Retractable Screen, Sliding Screen
• Design pressure: Matched to your Wellington wind zone, up to +/-100, never higher
• Compliance documentation: Miami-Dade NOA and Florida Product Approval numbers available per configuration

Every configuration we quote for a Wellington home is specified to match the wind zone of that exact address. We do not oversell design pressure. The right door is the one rated for your exposure, documented correctly, and installed to hold its rating.

Hurricane & Compliance Performance

Laminated Impact Glass - The glass package uses a PVB interlayer bonded between panes. Under large-missile impact, the glass may crack, but the interlayer holds the fragments in the frame. That keeps the building envelope closed during the storm, which is what protects the roof and everything inside from pressurization. The interlayer also adds sound damping and blocks most UV transmission.

Miami-Dade NOA / Florida Product Approval - Each door configuration carries its own Notice of Acceptance or Florida Product Approval number. The specific number depends on the frame material, glass package, and size, so we verify it on your written quote. Wellington building departments expect to see this documentation with the permit submittal, and we include it.

FBC / HVHZ Compliance - The impact series sliding doors are engineered to Florida Building Code High-Velocity Hurricane Zone requirements. HVHZ is not a marketing term; it is the governing standard for structures in Miami-Dade and Broward counties and the benchmark many Palm Beach County municipalities, including Wellington, reference for wind-borne debris protection.

TAS 201 / 202 / 203 Testing Context - HVHZ-rated doors are tested under a protocol family that includes TAS 201 for large-missile impact, TAS 202 for cyclic wind-pressure loading, and TAS 203 for forced-entry resistance. Together they simulate a hurricane’s sequence: debris hits, wind loads cycle, then the assembly must still resist entry. Our sliding glass and patio doors are specified from product lines tested under this framework.

Design Pressure Matched to Your Wind Zone - We match design pressure ratings to the wind zone of your specific Wellington property, and we quote up to +/-100 only where the location requires it. Overspecifying costs you money; underspecifying fails the permit review. We land on the number the code requires and document it.

Energy Performance Options - Low-E and insulated glass packages are available for homeowners who want the impact rating plus meaningful solar control. On west-facing Wellington exposures, Low-E reduces heat gain and helps keep afternoon cooling costs down without changing the door’s structural performance.

Color & Glass Options

The finish palette covers White, Almond, Bronze, Black, and Tan. In Wellington’s newer Mediterranean and transitional neighborhoods, bronze and black frames read as intentional architectural lines against stucco and stone. Almond and tan blend quietly on older Florida-style homes where the frame should recede. White remains the cleanest choice for coastal and contemporary elevations. All finishes are applied at the extrusion or paint level, designed to hold up under South Florida UV without fading or chalking within a few seasons.

Glass selection starts with your exposure and what the room needs. Clear laminated impact glass preserves the truest view and works well on shaded or north-facing elevations. Tinted glass cuts glare on east and west walls where afternoon sun is relentless. Low-E insulated glass adds thermal performance and pays back most noticeably on air-conditioned rooms with large glass area. If you want the view, the impact rating, and the energy performance, Low-E insulated laminated packages combine all three. We walk you through the trade-offs during the estimate so you pick the right glass for how you actually use the room.

Installation by TruePane Windows & Doors in Wellington

A sliding glass door with a Miami-Dade NOA is only as good as the opening it sits in. The product is tested as a complete assembly. The moment someone installs it out of square, skips the perimeter seal, or fails to flash the sill correctly, the NOA-rated performance no longer applies. That is the uncomfortable reality of hurricane-impact products, and it is why we treat every Wellington installation as a structural job, not a trim job.

Our process starts with a pre-install inspection of the existing opening. We measure the rough opening in three places horizontally and vertically, check the header and sill condition, and identify rot, settlement, or out-of-square framing before any material gets ordered. Then we set the new door level, plumb, and square, using shim patterns that transfer load, not just fill gaps. The perimeter gets sealed with AAMA 812 low-expansion foam, which insulates and seals without bowing the frame. Flashing and sill pan details follow, then the interior and exterior trim, then a final water test on the track and threshold before cleanup.

In Wellington, close attention goes to exposure. Homes on the preserve see different wind pressures than homes tucked into an interior lot, and the permit package has to reflect that. We coordinate with your permit submittal so the NOA or Florida Product Approval number on the door matches the documentation the building department sees. If the door is going onto a home built before current HVHZ requirements, we also check the existing header and lintel condition before committing to a 12-foot opening.

Improper installation compromises the rated system. It is that simple. We install these doors in Wellington the way the engineering assumes they will be installed, because the door only protects your home if the perimeter holds.

Frequently Asked Questions - Sliding Glass & Patio Doors

What wind zone and design pressure is the sliding glass patio door rated for?
The door is specified to match the wind zone at your Wellington address, with design pressures up to +/-100, and never higher than your exposure requires. We confirm the exact rating on your written quote based on your property’s wind zone and the door’s size and glass package. Call (561) 349-4826 for a property-specific specification.

What is the lead time for a sliding glass patio door in Wellington?
Typical lead times run several weeks from approval to delivery, depending on the line, finish, and glass package. Impact-rated glass is heavier and manufactured to order, so custom sizes and less common finishes extend the schedule. We provide a written lead time on your quote and keep you updated through production. Call (561) 349-4826 to start the process.

Does my Wellington permit require a Miami-Dade NOA or Florida Product Approval submittal?
Yes, in nearly every case. Wellington building departments want to see the NOA or Florida Product Approval number that matches the exact door configuration you are installing. We include this documentation with your permit submittal so the reviewed product matches the installed product. Call (561) 349-4826 and we will walk you through what your specific project needs.

Can I customize the size or configuration of my sliding glass door?
Yes, within the product engineering limits. The track configurations available are 2-track and 3-track, and the maximum panel width is up to 12 feet. Frame material, glass package, finish color, and screen type are all selectable. Custom sizes change the NOA or Florida Product Approval documentation, so we verify the rating for the final configuration before ordering. Call (561) 349-4826 to discuss your opening.

How do I maintain the frame and track on an impact sliding glass door?
Keep the track clear of sand and debris, clean the frame with mild soap and water, and avoid abrasive cleaners on the finish. Rollers on impact doors carry significant weight, so if the door starts to drag or bind, have the rollers and track inspected rather than forcing it. We service the doors we install in Wellington and will check roller condition and alignment during any service visit. Call (561) 349-4826.

Get a Quote - Sliding Glass & Patio Doors in Wellington

If you’re planning a sliding glass or patio door replacement in Wellington, start with a free on-site measurement and a written, line-item quote. We’ll match the door to your wind zone, walk you through glass and finish options, and handle the permit documentation. Call (561) 349-4826 to schedule your estimate.

Written by the team at TruePane Windows & Doors, installing hurricane-impact windows and doors in Wellington, FL since 2005.